Motorola BSR 2000 Configuration And Management Manual page 488

BSR 2000 Configuration and Management Guide
2. To display the configured network parameters for RIP, use the show ip protocols
Routing Protocol is
"rip
"
Sending updates every 30 seconds
Invalid after 180 seconds, flushed after 300
Outgoing update filter(s) list for all interfaces are:
Incoming update filter(s) list for all interfaces are:
Default redistribution metric is not set
Default version control: send version 2, receive version 1 and 2
Interface
-------------------- -- -- ---------------- ----- ------ ------ ------
ethernet 0/0
Interface
---------
9.1.1.1
11.1.1.1
13.1.1.1
14.1.1.1
16.1.1.1
17.1.1.1
15.1.1.1
8.1.1.10
Routing for Networks:
8.1.1.0
9.1.1.0
3. To display the entire contents of the private RIP database when triggered
10-12
in Privileged EXEC mode, as shown in the following example:
MOT# show ip protocols
Figure 10-1 gives an example of the show ip protocols command output:
SV RV
2 2 ****************
pkts recv pkts tx
--------- -------
0
0
0
0
0
0
0
661
Figure 10-1 show ip protocols Command Output
extensions to RIP are enabled, use the show ip rip database command in
Privileged EXEC mode, as shown in the following example:
MOT# show ip rip database
Figure 10-2 gives an example of the show ip rip database command output
Key KeyId PassIf SplHrz HostRt
routes new routes tx
---------- ---------
650 0
649 0
649 0
649 0
649 0
649 0
649 0
647 12
MGBI
Release 1.0
N Y Y
11887
11885
11885
11885
11885
11885
11885
11861
526360-001-00 Rev. B