Clearing Cable Interface Counters; Configuring Static Upstream Load Balancing - Motorola BSR 2000 Configuration And Management Manual

Release 1.0

Clearing Cable Interface Counters

Use the clear counters cable command in any mode to clear the counters for a cable
interface:
MOT# clear counters cable <X/Y>
where:

Configuring Static Upstream Load Balancing

Static upstream load balancing evenly distributes cable modems across multiple
upstream channels serving the same geographical community or Spectrum Group.
The term "static" means that the BSR will only attempt to move a cable modem to
another upstream channel after the registration process is complete. When enabled,
static upstream load balancing occurs automatically to move a newly
modem
Static upstream load balancing can be enabled or disabled per user-defined Spectrum
Group. By default, when a Spectrum Group is first created, the static upstream load
balancing feature will be disabled.
526360-001-00 Rev. B
mac optionally specifies a set of CM MAC addresses to reset counters by
masking a portion of the MAC address.
Use the clear cable modem counters command in Privileged EXEC mode to
clear and reset a specific CM's traffic counters from the station maintenance list
by using its IP address:
MOT# clear cable modem <prefix> counters
where:
prefix resets counters for a specified CM's IP address.
Use the clear cable modem all counters command in Privileged EXEC mode to
clear and reset all CMs' traffic counters on the BSR:
MOT# clear cable modem all counters
X is 0.
Y is the port number.
to the least loaded upstream channel.
MGBI
Configuring the CMTS
registered cable
6-177