Verifying The Cops Configuration; Configuring Event Messages; Enabling The Event Message System - Motorola BSR 2000 Configuration And Management Manual

Release 1.0

Verifying the COPS Configuration

Issue the show packet-cable configuration cops command in all modes except User
EXEC mode to display the COPS configuration and status information for the PEP
ID, Client Timer, and verify if the Status SNMP trap is enabled.
Figure 7-2
Figure 7-2 Output for the show packet-cable configuration cops Command.

Configuring Event Messages

Follow the procedures in these sections to configure event messages:

Enabling the Event Message System

Follow these steps to enable the event message system and specify an event message
Element ID for each BSR:
1. Issue the no em shutdown command in PacketCable Configuration mode to
2. Issue the em element-number command to specify a unique event message
526360-001-00 Rev. B
displays typical show packet-cable configuration cops command output:
MOT#show packet-cable configuration cops
COPS Configuration
------------------
PEP ID: Motorola CMTS
Client Timer: 4000 milliseconds
Status trap: disabled
Enabling the Event Message System
Configuring Event Message Parameters
Disabling Event Messages
Displaying Event Message Statistics
enable event messaging for the BSR.
Element ID for the BSR:
MOT(config-pktcable)# em element-number <0-99999>
where:
0-99999 is the Element ID number. The default is 0.
MGBI
Configuring PacketCable
7-9