Configuring A Modulation Profile Through An Iuc Submode - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide
Note: Modulation profiles 1-4, 101-116, 201-205, and 301-310 are
pre-configured modulation profiles.
Motorola recommends that user-created modulation profiles use the
numbering range of 401-600 to ensure better future portability.
For a complete list and configuration of all 23 pre-defined modulation profiles,
refer to

Configuring a Modulation Profile Through an IUC Submode

Follow these steps to configure modulation profile on an IUC submode by submode
basis:
1. Use the cable modulation-profile command in Global Configuration mode to
2. Use the commands shown in
Note: Modulation profiles 1-4, 101-116, 201-205, and 301-310 are
pre-configured modulation profiles.
Motorola recommends that user-created modulation profiles use the
numbering range of 401-600 to ensure better future portability.
For a complete list and configuration of all 23 pre-defined modulation profiles,
refer to
6-70
1-600 is a modulation profile number.
Appendix A.
enter Modulation Profile Configuration Mode for the modulation profile that you
want to configure or modify, as shown below:
MOT(config)# cable modulation-profile <1-600>
where:
1-600 is a modulation profile number.
IUC submode by submode basis.
Appendix A.
Table 6-11 to configure a modulation profile on an
MGBI
Release 1.0
526360-001-00 Rev. B