Using A Console Session To Access The Cli - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide

Using a Console Session to Access the CLI

This section describes accessing the CLI by connecting a terminal or PC with terminal
emulation software to the BSR's console port. The BSR supports one CLI session
through its console port. Before connecting to the BSR through a console session, the
following prerequisites must be met:
To start a console CLI session, do the following:
1. Connect to the BSR. The console session begins. The MOT> prompt displays.
2. Enter the enable command and press the Enter key.
3. Enter the password and press the Enter key to access Privileged EXEC mode.
For a detailed discussion of the different command line modes, refer to the
Command Modes
2-2
The terminal application on the terminal or PC uses COM port 1 or 2.
A physical connection exists between the BSR and the terminal or PC.
The console settings for the terminal or PC are set as shown in
Console Parameter
Baud Rate
Data Bits
Flow Control
Parity
Stop Bits
MOT >enable <Enter>
A Password: prompt displays.
The MOT # prompt displays.
section.
Table 2-1 Console Settings
Setting
9,600
8
None
None
1
MGBI
Release 1.0
Table 2-1:
CLI
526360-001-00 Rev. B