Release 1.0
private.enterprises.riverdelta.rdnCmtsMib.rdnCmtsMiscObjects.rdnCmtsCardType
Through the CLI:
Use the show running-config command to display the DOCSIS CMTS module type
as follows:
MOT (config)#show running-config | inc cmts type
Displaying Cable Interface Parameters
Select from the following options to view CMTS (cable) interface parameters:
526360-001-00 Rev. B
Use the show interfaces cable downstream command in all modes except User
EXEC mode to view a specified downstream port's statistics for a cable interface.
This command describes whether the downstream port is up or down, the number
of packets and bytes transmitted on the downstream port, how many packets are
discarded, the number of active CMs, and the associated upstream Spectrum
Group names.
MOT# show interfaces <X/Y> cable downstream <NUM>
where:
X is 0.
Y is the port number.
NUM is the downstream port number.
Use the show interfaces cable upstream command in all modes except User
EXEC mode to view a specified upstream port's statistics for a cable interface.
This command describes whether the upstream port is up or down, the number of
received broadcast, multicast, unicast, and unknown protocol packets, how many
packets are discarded or errored, the total number of received un-errored packet
count, the number of active or inactive CMs on this upstream port, the average
percentage of upstream channel utilization, and the associated Spectrum Group
name.
MOT# show interfaces <X/Y> cable upstream <0-7>
where:
X is 0.
MGBI
Configuring the CMTS
6-189