Motorola BSR 2000 Configuration And Management Manual page 509

Release 1.0
4. Use the ip ospf priority command in Interface Configuration mode to set priority
5. Use the ip ospf hello-interval command in Interface Configuration mode to
6. Use the ip ospf dead-interval command in Interface Configuration mode to set
7. Use the ip ospf authentication-key command in Interface Configuration mode to
8. Use the ip ospf message-digest-key command in Interface Configuration mode
526360-001-00 Rev. B
where:
1-3600 is the OSPF transmission delay in seconds.
of this router interface to determine the OSPF designated router on the OSPF
network:
MOT (config-if)#ip ospf priority <1-255>
where:
1-255 is the priority for this router interface.
specify the length of time between the hello packets that the software sends on an
OSPF interface:
MOT (config-if)#ip ospf hello-interval <1-65535>
the number of seconds that hello packets must be absent before the device
neighbors declare the OSPF router down:
MOT (config-if)#ip ospf dead-interval <1-65535>
where:
1-65535 is the number of seconds before the OSPF router is considered
down. The default is 40 seconds.
assign a password for neighboring OSPF routers to use on a network segment that
uses OSPF simple password authentication:
MOT (config-if)#ip ospf authentication-key <WORD>
where:
WORD is the unencrypted (clear text) with 1 to 8 characters.
to enable OSPF MD5 authentication:
MOT (config-if)#ip ospf message-digest-key {<1-255> md5 <WORD>}
where:
1-255 is the MD5 secret Key ID number.
MGBI
Configuring OSPF
11-19