Motorola BSR 2000 Configuration And Management Manual page 129

Release 1.0
ethernet 0/0 is up, line protocol is up
Hardware address is 00:30:b8:80:d9:31
Internet address is 192.168.110.2/24
MTU 1500 bytes, BW 100000 Kbits
Encapsulation
(Auto) Full-duplex, (Auto) 100Mb/s, 100BaseTx/FX
ARP Timeout 01:00:00
Last input 00:00:02, output 00:50:28
Last clearing of
"show interface
" counters never
Last state change at 00:24:29, 2 interface resets
Queueing strategy: FIFO
Output queue 0/100, 0 drops; input queue 0/0, 0 drops
379664 packets input, 19577257 bytes
Received 10951 broadcasts, 368161 multicasts
0 input errors, 0 CRC, 0 overruns
0 runts, 0 giants, 0 alignments
853 packets output, 1443110680 bytes
0 output errors, 0 collisions, 0 underruns
0 late collisions, 0 deferred
Figure 3-9 show controllers ethernet Command Output
526360-001-00 Rev. B
Figure 3-9 displays typical controller information for the Ethernet interfaces
on the BSR 2000:
Arpa
Use the show controllers gigaether command to display the following Gigabit
Ethernet module information:
MOT# show controllers gigaether <X/Y>
where:
X is 0.
Y is the Gigabit Ethernet port number.
MGBI
Configuring the System
3-79