Motorola BSR 2000 Configuration And Management Manual page 102

BSR 2000 Configuration and Management Guide
Specifying and Configuring a TACACS+ Server
Use the tacacs-server host command to specify and configure individual TACACS+
servers. The command can be used to configure multiple TACACS+ servers. The
TACACS+ client will contact the servers in the order in which they are specified.
MOT
<0-65535> | retry <0-100> | single-connection | timeout <1-1000>]
where:
3-52
Specifying a Global Retry Count
command authentication attempts that all TACACS+ clients make with all
TACACS+ server before going to the next configured/available TACACS+
server. The global retry count is used if no retry count is specifically configured
for this TACACS+ server.
Specifying a Global Timeout Value
seconds) that specifies the interval that all TACACS+ clients wait for a
TACACS+ server host to reply before an attempt to contact the TACACS+ server
times out.
Configuring an Interface for TACACS+ Packets
source IP address of all TACACS+ packets generated by the BSR by specifying a
loopback interface as the source IP address.
tacacs-server host {<hostname> | <A.B.C.D>} [key <WORD> | port
(config)#
hostname is the name of the TACACS+ server host.
A.B.C.D is the IP address of the TACACS+ server host.
key WORD specifies an alphanumeric authentication and encryption key. This
key must match the key used for this TACACS+ server.
port 0-65535 specifies a server port number. The port number specified here
overrides the default port number of 49.
retry 0-100 specifies the number of attempts that a TACACS+ client can make
when entering a command that is being authenticated by this TACACS+ server.
The default value is 3.
single-connection opens a new TCP connection for every TACACS session
established.
- A global retry count is the number of
- A global timeout value is a number (in
MGBI
Release 1.0
- An operator can control the
526360-001-00 Rev. B