Configuring Snmp Informs And Traps; Setting Trap Logging Control - Motorola BSR 2000 Configuration And Management Manual

BSR 2000 Configuration and Management Guide

Configuring SNMP Informs and Traps

SNMP traps and informs are disabled by default. SNMP traps are generated according
to standard and enterprise MIB specifications. The SNMP Agent maintains a
configuration of IP hosts to which traps are sent. This section provides information
for:

Setting Trap Logging Control

Trap logging control allows you to specify which type of trap messages are logged to
which destinations (console, SYSLOG, etc.) - either through the CLI or automatically
through the DOCSIS docsDevEvControlTable (refer to
Control
Note: Before configuring SNMP traps or informs, the type of logging control
must be specified.
In DOCSIS logging control mode, the BSR uses DOCSIS conventions for SYSLOG/
trap forwarding based on the DOCSIS standard. Each individual severity level (1-8)
can be enabled or disabled for trap reporting. This is achieved with the logging
reporting set of commands.
In proprietary logging control mode, the BSR can be configured to forward SNMP
traps for a specified severity level and higher. This is achieved with the logging
snmp-trap command. Proprietary logging control mode also provides a separate
threshold for SNMP trap rate throttling with the snmp-server trap rate-limit
command.
4-8
Setting Trap Logging Control
Configuring a Trap Destination
Enabling Informs
Enabling Traps
Restricting Trap Rates
Disabling Traps
Configuring a Loopback Interface for an SNMP Trap Source
on page 4-8).
MGBI
Release 1.0
Setting Trap Logging
526360-001-00 Rev. B