Configuring Communications Parameters; Connecting A Console Monitor - Motorola BSR 2000 Installation Manual

The following sections describe these tasks.

Configuring Communications Parameters

Set communications parameters on the terminal or PC with terminal emulation
software as listed in

Connecting a Console Monitor

To connect a terminal or PC to the BSR 2000, follow these steps and refer to
Figure
1. Connect one end of a shielded RS-232 crossover (null modem) cable to the
2. Connect the other end of the shielded cable (with the female DB-9 pin connector)
526359-001
Configure the terminal or terminal emulation software communication
parameters.
Physically connect the monitor or PC to the BSR 2000.
Table
Table 2-1 Console Monitor Communications Parameters
Parameter
Baud Rate
Data bits
Stop Bits
Parity
Flow Control
2-12.
RS-232 port on the terminal or PC.
to the male DB-9 pin connector labeled Console Port on the front panel of the
BSR 2000.
2-1.
Setting
9600
8
1
None (No parity)
None
MGBI
Performing Installation Tasks
2-17