Configure Snmp; Configure The Ethernet Ip Address - Motorola BSR 64000 Quick Start Manual

Configure SNMP

Follow these steps to configure SNMP on the BSR:
1. To enable all versions of SNMP running on the SNMP server, use the
snmp-server enable command in Global Configuration mode, as shown in the
following example:
RDN(config)# snmp-server enable
2. Configure SNMP server identification, access levels, packet size and traps.
3. Compile or import new SNMP MIBs.
4. Use an SNMP browser to configure or view MIBs.
Refer to the following documents for additional instructions:
•
BSR 64000 Configuration and Management Guide
•
BSR 64000 SNMP MIB Reference Guide
•
BSR 64000 Command Reference Guide

Configure the Ethernet IP Address

Follow these steps to assign the primary Ethernet IP address and subnet mask and
configure some basic system parameters:
1. To enter the Ethernet interface, use the interface ethernet command in Global
Configuration mode, as shown in the following example:
RDN(config)# interface ethernet <slot>/<port>
where:
slot is the SRM module slot on the BSR.
port is the port interface on the SRM module.
Quick Start
9