Task 13: Set up SNMP agent
Task 13: Set up SNMP agent
If SNMP is enabled, when an event occurs, the SNMP agent on the PTP 600 sends a
trap to whatever SNMP trap receivers have been configured.
Depending upon which SNMP version is required, choose one of the following
procedures::
•
Configuring generation of SNMPv3 notifications
•
Configuring generation of SNMPv1/2c notifications
Configuring generation of SNMPv3 notifications
Perform this task to enable the PTP 600 to generate Simple Network Management
Protocol version 3 (SNMPv3) traps.
Starting SNMP wizard
To start the SNMP wizard, proceed as follows:
Procedure 6-35 Start SNMP wizard
1
Select menu option Management, SNMP. The Current SNMP Summary
page is displayed
2
Review the summary.
3
If any updates are required, select Continue to SNMP Wizard.
Figure 6-49 Current SNMP Summary page (when SNMP is disabled)
6-90
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
(Figure
6-49).
Chapter 6 Configuration and alignment
on page
6-90
on page
6-99
phn-0896_012v000
Jul 2010