I/E Station Locations - Quantum Scalar i6000 User Manual

Chapter 13: Running Your Library
Understanding Location Coordinates
Figure 58 Example - I/O Blade
Location Coordinates

I/E Station Locations

470
Figure 58 shows an example of I/O blade location coordinates. The
location for the first I/O blade listed in the Connectivity dialog box is
reported as (1,1,1,1,3). This I/O blade is located in bay 3 of the left-most
module.
The location coordinates of an I/E station is based on the position of the
module that contains the I/E station. I/E stations are also distinguished
by whether they are an I/E stations or a HiCap I/E station.
• Single I/E Station: Designated by stating the module that contains it
(see Figure 59 on page 471).
• HiCap I/E Station: Designated by the modules that contains it but
since there are two I/E station doors, further designated by an A
(left) and B (right) (see
I/O blade location
coordinates
Figure 60 on page 472).
Quantum Scalar i6000 User's Guide