Quantum Scalar i6000 User Manual page 371

Quantum Scalar i6000 User's Guide
The Select Media for Details section of the screen lists each tape in
the test session. The following information is reported:
Item Description
Barcode The media barcode identifier.
Test Result The test result displays as one of the following:
• Good — The tape is good.
• Bad — The tape is bad.
• Suspect — The tape is possibly unreliable or
defective.
• Untested — The tape could not be fully scanned, for
various reasons, including: incompatible or unknown
media type; tape could not be loaded; tape is
encrypted but the data encryption key could not be
obtained; drive not communicating with I/O blade,
test was stopped.
Note: Untested media do not initiate RAS tickets or
• Not Completed — Test has not completed yet.
Drive ID The serial number of the tape drive that tested the tape.
State The current test status: Pending, In Progress,
Completed, Stopped or Paused.
Completed The date and time the test completed.
Type The type of test that was run: Quick Scan, Normal Scan
or Full Scan.
Chapter 9: Extended Data Lifecycle Management
Viewing EDLM Test Sessions and Report Details
EDLM media action policies (such as copying
data from a bad or suspect tape).
353