Setting Up Ipv4 Network Configuration - Quantum Scalar i6000 User Manual

Setting up IPv4
Network Configuration
Quantum Scalar i6000 User's Guide
2 If you are not already working from the physical library, select the
physical library from the View menu.
3 Do one of the following, depending on whether IPv6 is enabled or
disabled and the protocol of the network connection you want to
configure:
• IPv4 Configuration — Proceed to
Configuration
• IPv6 Configuration — Proceed to
Configuration
Note: The IPv6 Configuration sub-menu only appears if you
have enabled IPv6 for the physical library, as described
in Setting Up Policies for the Physical Library
page 180.
• DNS Configuration — Proceed to
page 170.
After completing the steps listed in
on page 162, select Setup > Network
Configuration
Configuration > Interface (#) > IPv4 Configuration. The IPv4
Network Configuration - Interface # dialog box appears.
Chapter 3: Configuring Your Library
Setting Up the Network Configuration
Setting up IPv4 Network
on page 163.
Setting up IPv6 Network
on page 167.
Configuring DNS
Setting Up the Network
on
on
163