Quantum Scalar i6000 User Manual page 625

Quantum Scalar i6000 User's Guide
3 Using the file chooser dialog box, locate the restore image file on
the remote file system.
4 When you have located the file and are ready to proceed, click
Open.
Note: Because the management control blade (MCB) determines
the name of the restore image file, you might not know the
file name when you are searching for it on the remote file
system. The file name always includes the library serial
number, date stamp, and time stamp, in that order and
separated by underscores.
An example file name might look like this:
213100020_2004-02-18_13.23.47.tar.gz
The serial number encoded in the image file must match
the library serial number. A serial number mismatch will
result in an message and the operation will not continue.
When image file compatibility has been established, the library
reboots itself and continues with restoring the configuration. The
reset operation could take minutes to complete. If you are near the
library and can see the library's touch screen, normal behavior is
when two "working" messages appear and the touch screen goes
dark when the LMC server restarts. From the remote client, a
message appears that indicates that the LMC server is reconnecting
to the client. After it reconnects, the LMC server performs a
discovery.
If the restore operation succeeds, a message appears that indicates
that the operation succeeded.
If the restore operation fails at any point, the library generates a RAS
ticket that contains details about the failure. Perform a revert or
rescue operation to return the library to a stable configuration.
5 After the restore operation has completed on the library, close and
restart the remote client.
6 If you have not done so already, make sure that the robotics are
enabled and bring the library back online so that data input and
output can continue.
Chapter 15: Maintaining Your Library
Maintenance Actions
607