Quantum Scalar i6000 User Manual page 202

Chapter 3: Configuring Your Library
Setting Up Policies for the Physical Library
184
proper library operation requires host applications to issue unload
commands to the drives. Automatic Drive Unload is enabled by
default.
Note: The Logical SN Addressing area is available only to CSEs.
You cannot enable or disable logical serial number
addressing for drives. If a CSE enables this feature, the
library assigns logical serial numbers to all drives in the
library. Specifically, the library assigns a logical serial
number to a drive in a specific location. This is not the serial
number of the particular drive. If a drive is replaced by
another drive in the same library location, the logical serial
number remains the same. From the host's perspective, the
replacement drive is the same as the original one.
6 Select Enable in the IPv6 area to enable the Network
Configuration dialog that you can use to configure the settings for
an IPv6 network connection.
Note: IPv6 is disabled by default.
Note: Enabling IPv6 adds a sub-menu to the Network
Configuration command on the Setup menu that you use
to display the IPv4 or IPv6 Network Configuration dialog.
7 Select Enable in the Extended I/E area to enable the Extended I/E
feature.
Note: Extended I/E is disabled by default.
Note: Extended I/E allows the user the capability to increase the
number of I/E slots presented to the host. For more
information, refer to
8 Select Enable in the EKM Path Diagnostics area to enable
Encryption Key Management background diagnostics.
The diagnostics test determines whether the EKM servers are
connected and operating properly. The test runs in the background
at regular intervals and generates a RAS ticket if key server
connectivity issues are found. For more information about the tests
I/E Station Options on page 26
Quantum Scalar i6000 User's Guide