Advanced Control Path
Failover
Quantum Scalar i6000 User's Guide
2 Click the Failover button.
3 A warning message appears informing that switching the active
control path drive could cause temporary loss of communication to
the host application.
4 If you still want to perform this operation, click Yes to continue. The
new active control path drive is configured.
5 Click OK.
Requirements
To configure drives for advanced control path failover, you need the
following:
• A Storage Networking (SNW) License must be installed on the
library (see
Enabling Licenses
Chapter 10: Path Failover
Configure Control Path
on page 125).
369