Quantum Scalar i6000 User Manual page 372

Chapter 9: Extended Data Lifecycle Management
Viewing EDLM Test Sessions and Report Details
354
2 To view test details for a specific tape, click on a row in the Select
Media for Details section to highlight it. Details about the test
display in the Details section below. The following details display:
Item Description
CM Scan Status One of the following:
• Test completed — Test is finished; however, the
• Test paused.
• Test pending.
• Test in progress.
• Test not run — Media was removed from
CM Scan Summary of the cartridge memory scan (either
Analysis "good" or an explanation of the result).
Tape Scan Status One of the following:
• Test completed — Test is finished; however, the
• Test paused.
• Test pending.
• Test in progress.
• Test not run — Media was removed from
• Test not configured — You requested a Quick
Tape Scan Summary of the tape scan (either "good" or an
Analysis explanation of the result).
3 To send a copy of the test session report via e-mail, click Send. To
update the dialog with the current status, click Refresh.
result may not be "good." You can also get this
if the test was stopped.
library before it could be tested, or there were
no drives available to test the media.
result may not be "good."
library before it could be tested, or there were
no drives available to test the media.
Scan only so the tape was not scanned.
Quantum Scalar i6000 User's Guide