Quantum Scalar i6000 User Manual page 171

Quantum Scalar i6000 User's Guide
Drives of the specified type within the partition appear in the
table.
Note: All drives of the specified type within the partition are
listed, regardless of whether they are attached to an FC
I/O blade or Ethernet Expansion blade.
If you need to download a new drive firmware image to use
with drives that you want to participate in auto leveling
operations, perform the procedure under
Firmware on page 592, and then proceed with the next substep.
Otherwise, proceed directly to the next substep.
After you download a new image, the new drive firmware
version is automatically added to the Firmware Version drop-
down list.
b In the left-most column of the table in the Selected Drives will
be Autoleveled area, select one or more check boxes that
correspond to drives that you want to update with the same
drive firmware version, and then click the version in the
Firmware Version drop-down list.
Note: Only drives that are attached to an FC I/O blade or an
Ethernet Expansion blade can participate in drive
firmware autoleveling operations.
19 To continue, click Next. The Partitions - Summary Information
dialog box appears.
20 Verify that the parameters you set are correct.
21 If the summary information is correct, click Modify. The Partitions -
Completed dialog box appears.
Note: After you click Modify, the Cancel button becomes
unavailable.
22 Review the information to make sure it is correct.
23 If you want to view the drive information after modifying the
partition, click Next.
24 Click Finish. The Partitions dialog box appears again.
25 Click Close.
Chapter 3: Configuring Your Library
Working With Partitions
Updating Drive
153