Quantum Scalar i6000 User Manual page 561

Table 49 Partition Status
Element
Name
Status
Media Type
Interface
#Drives
#Storage Slots
#I/E Slots
Media Type Checking
Media Identifier
Drive Autolevel
Auto Drive Clean
Encryption
LCP WWPN
Library Type
Quantum Scalar i6000 User's Guide
Table 49 on page 543 describes the elements on the Partitions
Status dialog box.
Description
The name of the partition.
The status of the partition (Online or Offline).
The type of media used in the partition (LTO-1, LTO-2, LTO-3, LTO-4, LTO-5,
LTO-6 or LTO-7).
The type of interface used to connect to the host (FC).
The number of tapes drives in the partition.
The number of storage slots in the partition.
The number of I/E station slots in the partition.
The current setting for media type checking (Required, Not Required, or
Disabled).
The current setting for return media identifier (Suffix, Pass Through, Prefix,
or Disabled).
The current setting for drive firmware autoleveling (Enabled or Disabled).
The current setting for automatic drive cleaning (Enabled or Disabled) as
well as the number of motion hours set for each drive cleaning.
Defines the encryption method for the partition. The values are Not
Supported, Application Managed, or Library Managed. If the partition is
enabled for FIPS, "FIPS" appears in parentheses.
The Library Control Path (LCP) World Wide Port Name (WWPN) for a
partition. A WWPN will only be listed if control path or control path
failover is used to present the partition to the SAN.
Logical library/partition type - either Standard or Library Managed. If
library managed, the type of library managed partition is listed in
parentheses (for example, AMP, EDLM, or VAULT).
Chapter 15: Maintaining Your Library
Monitoring the Library
543