Specifying The Date And Time - Quantum Scalar i6000 User Manual

Specifying the Date and Time

Quantum Scalar i6000 User's Guide
included in the diagnostics, see
page 311.
Default configurations are as follows:
• Q-EKM — Not available.
• SKM — Enabled by default. You can disable it for SKM but it is
not recommended unless directed by a service technician. The
background diagnostic should always be enabled so the library
can monitor SKM server status and report issues as soon as they
arise.
• KMIP key managers - Enabled; cannot be disabled.
9 When finished, click OK.
You can use the Date and Time command to set or reset the system
time. If you want to synchronize the library over a network, you can use
the Network Time Protocol (NTP) setting. The default date and time is
Greenwich Mean Time (GMT).
To set the date and time or to use NTP:
1 Log on as an administrator.
2 Make sure that you are viewing the physical library. From the View
menu, click the name of the physical library.
3 Click Setup > Date and Time. The Date and Time dialog box
appears.
Chapter 3: Configuring Your Library

Specifying the Date and Time

Using EKM Path Diagnostics on
185