Quantum Scalar i6000 User Manual page 420

Chapter 10: Path Failover
Configuring Host Access to Storage Networking Drives and Partitions
402
13 Click Next to display the Select the partitions for host access
dialog box. In order for a partition to appear on the list, both the
following conditions must apply:
• the partition has its control path configured via control path
bridging (meaning, the control path is via an HP LTO-5 or later
drive connected to an Ethernet Expansion blade); and
• the control path drive has an SNW license applied to it.
14 To add partitions to the host access group, select their check boxes
in the Select column.
For each partition selected, make sure to select either Port 1 or Port
2 for processing host medium changer commands (the default is
Port 1). Both drive ports are active and have different WWPNs, so
the port you choose must be physically connected to a host or
switch or the host will not see it. The port you choose depends on
which ports on the control path drive are physically cabled.
15 Click Finish to create the new access group.
16 Click OK in the The Host Access was updated successfully dialog
box.
Quantum Scalar i6000 User's Guide