Quantum Scalar i6000 User Manual page 358

Chapter 9: Extended Data Lifecycle Management
Configuring EDLM
Media Scan
Type Policy Description
Quick Scan Does not scan the tape. Evaluates data from the cartridge memory (CM) only.
A quick scan takes less than one minute per tape.
Examples of when to use a quick scan:
• When you first import previously used scratch tapes into the library.
• When you import data cartridges that have been used in other backup and
Normal Scan Evaluates the cartridge memory (CM) and scans selected portions of the tape,
(default) focusing on areas most likely to indicate problems.
A normal scan can take 20 minutes per tape.
Examples of when to use a normal scan:
• For tapes in frequent use within the library, with scanning triggered by drive-
• For tapes in frequent use within the library, with scanning being performed at
Full Scan Evaluates the cartridge memory (CM) and scans the entire tape.
A full scan can take more than 2 hours on a full tape.
Example of when to use a full scan:
• When tape cartridges are accessed infrequently and are used primarily for on-
• When tape cartridges with valuable data are introduced into the library and the
340
archival environments and need to do a quick check to determine whether the
tape cartridge is nearing end of life, at end of life, or may have had issues
reading or writing.
reported media Tape Alert events.
regular time intervals.
site or off-site long-term data retention.
state and condition of the tapes are unknown.
8 Select a scan priority from the Policy Scan Priority drop-down list
(Low, Medium, or High). The default is medium. The priority is used
to queue scans when there are too many to be performed
concurrently.
9 Select the maximum number of concurrent scans allowed from the
Concurrent Scans drop-down list. The maximum allowed (default)
is the number of scanning drives in the EDLM partition.
10 Click Next. The EDLM Media Scan Results Action Policies screen
appears.
Quantum Scalar i6000 User's Guide