Logging On To The Cli; Chapter 14 Using The Command Line Interface - Quantum Scalar i6000 User Manual

Tape library
Hide thumbs Also See for Scalar i6000:
Table of Contents

Advertisement

Chapter 14: Using the Command Line Interface

Logging on to the CLI

Logging on to the CLI

498
1 Enable CLI on the library:
a From the LMC, select Setup > Security.
b Under CLI, select the Enable radio button.
c Under SSH, select the Enable radio button.
Note: Both the CLI and SSH must be enabled in order to use
the command line interface.
d Click OK.
For more information on library security settings, see
Library Security
on page 235.
2 Use SSH to access the CLI.
Note: When using Putty or Tera Term on Windows, enter the user
name and password in boxes.
When using Linux, log in as:
(where
<ip>
3 When prompted for the user name, type:
Note: The only user name supported on the CLI is
4 When prompted for the password, type the admin password
configured on the library. The main CLI screen appears.
Welcome to the XXX Library Command Line Interface.
Type 'help' at the prompt for context-sensitive help.
/>
ssh admin@library_<ip>
is the IP address of the library).
Quantum Scalar i6000 User's Guide
Configuring
.
admin
.
admin

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Scalar i6000 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Sci6000

Table of Contents

Save PDF