Basic Independent Key Transition Operations; Setting The Independent Key Transition Type - Sony XVS-G1 User Manual

When the common transition and independent
key transition are executed at offset times
If a key is inserted:
The key is removed in both transition types at offset
times. When the common transition ends, both
transitions are completed even if the independent key
transition is in progress.
If a key is not inserted:
The key is inserted in the transition of the first
executed transition type. Subsequently, the key is then
inserted, so that when the transition with the other
transition type is executed the key will be removed.
The transition is completed at the point when the key
is removed.
Basic Independent Key Transition
Operations
The basic independent key transition operation flow is as
follows.
1
Select a transition type for the independent key
transition.
Select an independent key transition type using the
Flexi Pad control block or the menu.
For details about transition types, see "Setting the
Independent Key Transition Type" (page 67).
2
Set the transition type.
Make the required settings for the selected transition
type.
• Transition rate settings (see page 68)
• Wipe settings (see page 108)
• DME wipe settings (see page 120)
Using transition preview mode, you can check the
status of the transition.
For details about transition preview, see "Transition
Preview" (page 65).
3
Execute the independent key transition.
Execute the transition using the buttons in the
independent key transition execution section on the
transition control block.
For details about executing transitions, see
"Executing an Independent Key Transition"
(page 69).
Setting the Independent Key
Transition Type
You can set the way in which the independent key
transition occurs.
The independent key transition type is configured using
the Flexi Pad control block or the menu.
Note
When an operation mode that supports configuration of
transitions where keys are inserted/removed independently
is set, the transition type for inserting and removing keys
can be set separately.
For details about independent key transition operation
mode, see "Setting the Independent Key Transition Mode"
(page 311).
Setting the independent key transition
type (Flexi Pad control block)
You can set the independent key transition type using the
Flexi Pad control block of the target switcher bank.
1
Press the [KEY] button.
The memory recall section switches to key operation
mode.
2
Select the target key to set.
Press a [KEY1] to [KEY8] button, turning it on.
3
Select a transition type.
Press the [MIX] button, [WIPE] button, or [DME
WIPE] button, turning it on.
4
Set the transition type.
Make the required settings for the selected transition
type.
When a mix, wipe, or DME wipe is selected
Set the transition rate.
For details about the transition rate, see "Setting the
Independent Key Transition Rate" (page 68).
When a wipe is selected
Set the wipe pattern.
For details, see "Setting an Independent Key
Transition Wipe" (page 108).
When a DME wipe is selected
Set the DME wipe pattern.
For details, see "Setting an Independent Key
Transition DME Wipe" (page 120).
67