Setting M/E Split; Setting A Gpu; Setting Dme Channel Enhanced Function Mode - Sony XVS-G1 User Manual

Move to video playback stop point
Move to end of video content
[Variable Speed] button
[Set Loop Playback] button

Setting M/E Split

You can split an M/E hardware block (physical M/E block)
of the switcher for use as two sub blocks.
You can assign a logical M/E to each sub block.
For details about assigning a logical M/E, see "Assigning
a Logical M/E" (page 306).
Notes
• Enabling M/E split will disable multi program 2 mode.
• When M/E split is enabled, the Out5 to Out8 outputs
cannot be used.
• When M/E split is enabled, the keys that can be used in
a single physical switcher block can be assigned to the
two sub blocks. You can set the number of keys to
assign.
For details about setting keys, see "Setting Sub Block
keys" (page 306).
1
Open the Home > Setup > System > Format/Config >
M/E Split menu (19101.24).
2
Select the target physical M/E block to set.
3
Set the [M/E Split] switch to the on state.
To disable M/E split, set the [M/E Split] switch to the
off state.
4
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
5
Check the message, then press [OK].
The switcher system reboots.

Setting a GPU

The DME and SL key functions use a GPU.
When the system signal format is 2160P, either the DME
function or SL key function can be enabled.
Notes
• To use the DME and SL key functions, the XKS-G1600
GPU Pack (option) must be installed.
To use the DME function, the XZS-G1610 3D DME
License (option) is required. To use the SL key function,
the XZS-G1620 SL Key License (option) is required.
• The DME function is not supported in version 1.0.
Setting a GPU enables the SL key function.
1
Open the Home > Setup > System > Format/Config >
GPU Config menu (19101.25).
2
In the [GPU Config] group, select a function to enable.
DME: Enable DME.
SL Key: Enable SL key.
3
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
4
Check the message, then press [OK].
The switcher system reboots.
Setting DME Channel Enhanced
Function Mode
1
Open the Home > Setup > System > Format/Config >
GPU Config menu (19101.25).
2
Set enhanced function mode.
To set DME channel 1
In the [DME Channel 1] group, enable/disable
enhanced function mode.
Enhanced: Enable enhanced function mode.
Normal: Disable enhanced function mode.
To set DME channel 2
In the [DME Channel 2] group, enable/disable
enhanced function mode.
Enhanced: Enable enhanced function mode.
Normal: Disable enhanced function mode.
3
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
4
Check the message, then press [OK].
The switcher system reboots.
286