Setting The Source And Destination Names - Sony MVS-8000 User Manual

Setting the Source and Destination Names

To set the Source and Destination names used in the control panel, use the
following procedure.
Notes
Before carrying out these settings, it is necessary to set the number of the S-Bus
description name.
For details of the operation, see "Setting the group number of an S-Bus
description name" (page 1290).
1
2
To replace a name set in the Xpt Assign menu with an S-Bus
description name
Turn [S-Bus Name Link] on. This has such effect that each time a description
name is changed on the router, the corresponding source name is automatically
changed. Thus, the same description name can always be used both on the
router and the switcher.
Even when [Sw'er Local] is selected, the same name as when [S-Bus Descript]
is selected can be displayed. The S-Bus description name can also be displayed
in the Xpt Assign menu.
1190
Operation Settings (Operation Menu)
In the <Source/Dest Name> group of the Panel >Operation menu, select
the names to be used from the following.
Sw'er Local: Source names set in the Xpt Assign menu, and fixed bus
names
S-Bus Descript: Description names set in the router
S-Bus Type + Num: Type + Num set in the router (In this case always
eight characters.)
In the <Name Display Mode> group, select the method of display in the
source name displays.
Auto: Optimize display according to number of characters. A name of up
to two characters appears as two characters in one line. A name of up
to four characters appears as four characters in one line.
Otherwise, up to the first eight characters are shown in two lines.
2 Character: The first two characters appear.
4 Character: The first four characters appear.