Wind Settings - Sony MVS-6520 User Manual

Leaving a trail of afterimages of the image
1
Open the DME >Light/Trail >KF Strobe menu (4154).
2
Press [KF Strobe], turning it on.
3
Set the following parameter.
No. Parameter Adjustment
1 Decay Defocusing of the video signal
4
To erase the afterimages, press [KF Strobe Eraser],
turning it on.
Selecting the overlay priority for movie and
still images (video freeze image)
In the <Priority> group of the KF Strobe menu (4154),
select the method of superimposition.
Over: The movie is on top, and the still image is
underneath.
Under: The movie is underneath, and the still image is on
top.
Mix: The movie and still images are mixed; adjust the
following parameter.
No. Parameter Adjustment
1 Mix Mix amount of the still image with
respect to the movie
Selecting the freeze timing
In the <KF Freeze Timing> group of the KF Strobe menu
(4154), select the timing for freezing the keyframe strobe.
Frame: Freeze in frame units.
Field: Freeze in field units.
Notes
The freeze timing setting is not required when the
following signal formats are being used.
720P/50, 720P/59.94, 1080PsF/23.976, 1080PsF/24
Erasing the afterimages that remain in
memory whenever a keyframe is passed
In the KF Strobe menu (4154), press [KF Strobe Eraser],
turning it on.
When the effect passes a keyframe, the afterimage is
erased before writing a new afterimage.
Applying stardust to the afterimage
portion
The afterimage portion becomes stardust, and gradually
disappears.
1
In the KF Strobe menu (4154), press [Dust], turning it
on.
2
Set the following parameters.
No. Parameter Adjustment
1 KF Strobe Amount of the afterimage
Dust disappearing as stardust
2 Dust Soft Timing with which stardust
disappears
3 Dust Size Size of stardust
4 Dust Aspect Aspect ratio of stardust
a) The way in which the afterimage disappears is affected by both the
Decay and KF Strobe Dust parameter adjustments for the keyframe
strobe.
Disabling the keyframe strobe afterimage
In the KF Strobe menu (4154), press [KF Strobe Disable],
turning it on.
If you turn this function on when creating a keyframe, even
as the effect passes a keyframe, no afterimage remains.
Setting a combine process
Select whether to add the Keyframe Strobe effect before or
after the combine.
Notes
• The combine process function is not supported by the
MKS-6570 or MVE-8000A.
• When you change the selection in the <Combine
Process> group, the afterimages which had been added
up to then disappear.
• When you do not combine images, the Keyframe Strobe
effect only is applied, regardless of the selection in the
<Combine Process> group.
Select one of the following in the <Combine Process>
group of the KF Strobe menu (4154).
Combine –> KF STRB: Add the Keyframe Strobe effect
after the combine.
As parameters, the data for the channel with the lowest
number among the channels being combined is
enabled.
KF STRB –> Combine: Add the Keyframe Strobe effect
before the combine.
Parameters can be set independently for each channel.

Wind Settings

Notes
• The Wind function is not supported by the MKS-6570 or
MVE-8000A.
Applying Special Effects (Lighting and Recursive Effects)
a)
207