Wind Settings - Sony MVS-8000X User Manual

Disabling the keyframe strobe afterimage
Press [KF Strobe Disable], turning it on.
If you turn this function on when creating a keyframe, even
as the effect passes a keyframe, no afterimage remains.
Setting a combine process
Select whether to add the Keyframe Strobe effect before or
after the combine.
Notes
• The combine process function is not supported on the
MVE-8000A.
• When you change the selection in the <Combine
Process> group, the afterimages which had been added
up to then disappear.
• When you do not combine images, the Keyframe Strobe
effect only is applied, regardless of the selection in the
<Combine Process> group.
Select one of the following in the <Combine Process>
group.
Combine –> KF STRB: Add the Keyframe Strobe effect
after the combine.
As parameters, the data for the channel with the lowest
number among the channels being combined is
enabled.
KF STRB –> Combine: Add the Keyframe Strobe effect
before the combine.
Parameters can be set independently for each channel.

Wind Settings

Notes
• The wind function is not supported on the MVE-8000A.
• When wind is turned on, any of the following effects that
are on are turned off.
- Trail
- Motion decay
- Keyframe strobe
Applying the wind effect
1
In the DME menu, select VF5 'Light/Trail' and HF5
'Wind.'
The Wind menu appears.
2
Press [Wind], turning it on.
3
Set the following parameters.
286
Applying Special Effects (Lighting and Recursive Effects)
Knob Parameter Adjustment
1 Decay Amount of
afterimage
displayed
2 Shift H Extension in the
horizontal
direction
3 Shift V Extension in the
vertical
direction
a) 0.00 represents no afterimage, and 100.00 represents no decay in the
afterimage.
4
To erase the afterimages, press [Wind Eraser], turning
it on.
Selecting the signal for the afterimage
portion
In the <Wind Source> group, select the image to fill the
afterimage portion.
Notes
• "Mix Color" or "Ext Video" can only be applied to one
of the background (see page 295), flex shadow (see page
247), trail (see page 282), and wind effects.
If you select "Mix Color" or "Ext Video" in the wind
settings, a selection of "Mix Color" or "Ext Video" in
any of the other effects is disabled, and "Flat Color" is
selected in its place.
• When executing combining four channels of DME
images, "Mix Color" and "Ext Video" cannot be
selected.
Freeze Video: Freeze the input image to use as the
afterimage.
Flat Color: Use a single color matte for the afterimage;
you can set the following parameters with the knobs.
Knob Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
Hue Rotate: Use a single color matte with the hue
changing for each frame as the afterimage; you can set
the following parameters with the knobs.
Knob Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Rate at which
Speed hue changes
Mix Color: Insert a mix color signal (see page 253) in the
afterimage portion.
Setting values
a)
0.00 to 100.00
–100.00 to
+100.00
–100.00 to
+100.00
Setting values
0.00 to 100.00
0.00 to 100.00
359.99 to 0.00
Setting values
0.00 to 100.00
0.00 to 100.00
–12.00 to +12.00