Advertisement
Returning parameters to the initial
settings
Press the default recall button.
The parameters return to the initial status saved data
setting values.
Entering parameters using the utility
control block
Press the [MENU] button in the utility control block to
switch to menu parameter operation mode.
You can set parameters of the currently displayed menu
using the adjustment knobs.
Adjustment knobs 1 to 5 correspond to the parameter 1 to
5 buttons. Adjust parameters by turning the adjustment
knobs clockwise or counterclockwise.
Note
The control panel must be linked with the menu.
For details, see "Linking a Control Panel with the Menu"
(page 76).
Setting parameters using the device
control block
Press the [MENU] button in the device control block to
switch to menu parameter operation mode.
You can set parameters of the currently displayed menu
using the trackball and Z-ring.
• The trackball X-axis direction corresponds to the
parameter 1 button. Adjust the parameter by moving the
trackball left/right.
• The trackball Y-axis direction corresponds to the
parameter 2 button. Adjust the parameter by moving the
trackball up/down.
• The Z-ring corresponds to the parameter 3 button.
Adjust the parameter by turning the Z-ring clockwise or
counterclockwise.
• Press the [FINE] button to switch to fine mode,
enabling fine adjustment of setting values using the
trackball and Z-ring.
Note
The control panel must be linked with the menu.
For details, see "Linking a Control Panel with the Menu"
(page 76).
Initializing Settings (Default Recall)
You can return a menu to the initial status saved data
setting value if a default recall button is displayed.
Notes
• You can initialize a parameter setting values using a
default recall button in the analog controls window.
For details, see "Returning parameters to the initial
settings" (page 74).
• You can initialize a key setting values using buttons in
the key control block.
For details, see "Initializing Key Settings" (page 136).
• You can initialize switcher bank and two-dimensional
transform (resizer) setting values using buttons in the
device control block.
For details, see "Reducing, enlarging, moving, and
rotating keys (device control block)" (page 138).
• You can initialize three-dimensional transform (DME)
setting values using buttons in the device control block
or the menu.
For details, see "Three-Dimensional Transform
Operations (Device Control Block)" (page 200) and
"Three-Dimensional Transform Operations (Menu)"
(page 203).
Default recall button
1
Press the [Default Recall] button.
2
Check the message, then press [OK].
The menus below the selected level 3 menu return to
their initial settings.
Note
In the case where a level 3 menu does not exist, the
menus below the level 2 menu return to their initial
settings.
Default recall target menus
• Home > M/E-x > Keyx menus
• Home > M/E-x Sub > Keyx menus
74
Advertisement
Chapters
