Nmos Function Settings - Sony XVS-9000-C Service Manual

Item name Description
Mode Used to display the right to access the MIB information.
Trap Settings
This function makes the settings for trap notification to the SNMP manage. Click [Apply] to immediately apply the
settings.
Item name Description
Enable/Disable Used to enable or disable the SNMP Trap function.
Name Used to set the SNMP community name.
Network Interface Used to display the corresponding network interface.
Destination IP Ad- Used to enter the trap destination address.
dress
Destination Port Used to enter the port number of the trap destination address.
Version Used to select the SNMP version.
Test Trap
Clicking [Send] notifies the test trap for system verification according to the trap settings.
MIB data
Clicking [Retrieve] opens another tab of the web browser to display the MIB information.
1-14-7.

NMOS Function Settings

This section describes settings for NMOS of the IP Video Interface (ST2110) board.
Use the [NMOS] tab of the web menu to make the settings.
Note
To make the NMOS function available, the board firmware version must be 1.40 or later.
XVS-9000-C/XVS-8000-C/XVS-7000-C/XVS-6000-C
Range or choices (under line: Ini-
tial value)
READ_ONLY
Range or choices (under line: Ini-
tial value)
Enable
Disable
Up to 64 ASCII code characters
public
XKS-C81XX 1st: LAN1/1
XKS-C81XX 2nd: LAN2/1
XKS-C91XX 1st: LAN1-1/1
XKS-C91XX 2nd: LAN2-1/1
0.0.0.0 to 255.255.255.255
0 to 162 to 65535
V1
V2C
1-34