Applying Special Effects (Common Operations); Applying Special Effects (Edge Effects); Border Settings - Sony XKS-C9111 User Manual

Applying Special Effects
(Common Operations)
This section describes the operation of each effect using
the setup procedure in the DME menu.
Select the DME channel in the device control block
(trackball) before operating the menu.
Selecting a DME channel
1
Press the [DME] button on the device control block.
2
Using the channel selection buttons, select the target
channel (CH1 to CH4) of the operation.
3
Configure each effect in the DME menu.
Applying Special Effects
(Edge Effects)

Border Settings

Adding a border
1
Open the DME >Edge >Border/Crop menu (4111).
2
Press [Border], turning it on.
3
Set the following parameters.
No. Parameter Adjustment
1 H
2 V
3 All
5 Density
No. Parameter Adjustment
1 Top
2 Left
3 Right
4 Bottom
5 Density
Selecting the border color
1
In the <Border Fill> group of the Border/Crop menu
(4111), select one of the following.
Flat Color: Single color
Mix Color: Mix color signal set in the DME >Edge
>Color Mix menu (4117) (see page 241)
Ext Video: External video signal input from Ext In
2
When [Flat Color] is selected in step 1, set the
following parameters.
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation
3 Hue
230
Parameter group [1/2]
Simultaneously adjust border width
of left and right edges
Simultaneously adjust border width
of top and bottom edges
Simultaneously adjust border width
on all edges
Border density
Parameter group [2/2]
Border width on top side
Border width on left side
Border width on right side
Border width on bottom side
Border density
Saturation
Hue