Frame Memory Clip Function - Sony MVS-8000X User Manual

Notes
• The effect is built with the selected files, in
increasing order of the last three characters of the
file name. If you do not want to include some of
these files in the effect, first delete or rename them.
• A maximum of 99 keyframes can be included in a
single effect.
Recalling a sequence of still images
Run the effect created by the foregoing procedure.
The procedure for doing this is the same as for any other
effect.
For details, see "Executing Effects" in Chapter 13
(Volume 2).
Frame Memory Clip
Function
What is a "frame memory clip"?
Movies can be read into frame memory, and recalled and
played back. A movie held in frame memory is called a
"frame memory clip."
A frame memory clip can be named using up to four
characters (see page 165).
Ancillary data
In a frame memory clip, in addition to the video image,
you can also record and play back ancillary data which can
be used as embedded audio.
To record the ancillary data, in the Setup menu the frame
memory saving mode must be set to "save with ancillary
data".
For details, see "Saving a Frame Memory Clip With
Ancillary Data" in Chapter 18 (Volume 2).
Notes
• With this setting, the saving mode for still images also
changes to "save with ancillary data," but when playing
back a still image the ancillary data is never played.
• When you change the saving mode, the frame memory is
initialized, and any existing recorded frame memory
data is lost.
• When the signal format is 1080P, ancillary data is not
supported.
Note on transferring ancillary data
Ancillary data is recorded when the frame memory saving
mode is set to "save with ancillary data," and can be saved
to an external storage device such as a hard disk or
memory card, and recalled. However, the ancillary data
can only be saved or recalled;
• When the frame memory saving mode is set to "save
with ancillary data.
• When ancillary data is present in the saved or recalled
frame memory file.
• When the system signal format is the same as the signal
format in the file.
When the frame memory saving mode is set to "save with
ancillary data," the following ancillary data status
information is added to a frame memory clip.
• Disable(d):
In this state the ancillary data is not played. This is the
status when the [Ancillary Enable] button in the Frame
Memory >Clip menu is set to Off.
• Enable(d):
In this state, ancillary data is present, and can be played
167

Frame Memory Clip Function