Advertisement
RIP C
OMMANDS
(RIP)
FULLUPDATE
fullupdate (RIP)
Overview
Use this command to specify which routes RIP should advertise when performing
a triggered update. By default, when a triggered update is sent, RIP will only
advertise those routes that have changed since the last update. When fullupdate
is configured, the device advertises the full RIP route table in outgoing triggered
updates, including routes that have not changed. This enables faster convergence
times, or allow inter-operation with legacy network equipment, but at the expense
of larger update messages.
Use the no variant of this command to disable this feature.
fullupdate
Syntax
no fullupdate
Default
By default this feature is disabled.
Mode
RIP Router Configuration
Example
To enable the fullupdate (RIP) function, use the commands:
awplus#
awplus(config)#
awplus(config-router)#
613-50137-01 Rev A
configure terminal
router rip
fullupdate
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
658
Advertisement
Troubleshooting
