Centrecom FS980M/9 Command Reference Manual page 596

IP A P
DDRESSING AND ROTOCOL
SHOW IP SOCKETS
Table 19: Parameters in the output of the show ip sockets command
613-50137-01 Rev A
C
OMMANDS
tcp :::23
udp 0.0.0.0:111
udp 226.94.1.1:5405
udp 0.0.0.0:161
udp :::161
raw 0.0.0.0:112
raw :::58
raw :::112
Parameter Description
Not showing
This field refers to established sessions between processes internal
<number>
to the device, that are used in its operation and management.
local
These sessions are not displayed as they are not useful to the user.
connections
<number> is some positive integer.
Not showing
This field refers to listening sockets belonging to processes internal
<number>
to the device, that are used in its operation and management. They
local
are not available to receive data from other devices. These sessions
listening
are not displayed as they are not useful to the user. <number> is
ports
some positive integer.
Typ
This column displays the type of the socket. Possible values for this
column are:
tcp : IP Protocol 6
udp : IP Protocol 17
raw : Indicates that socket is for a non port-orientated protocol (i.e.
a protocol other than TCP or UDP) where all packets of a specified IP
protocol type are accepted. For raw socket entries the protocol type
is indicated in subsequent columns.
Local
For TCP and UDP listening sockets this shows the destination IP
Address
address and destination TCP or UDP port number for which the
socket will receive packets. The address and port are separated by ':' .
If the socket will accept packets addressed to any of the device's IP
addresses, the IP address will be 0.0.0.0 for IPv4 or :: for IPv6. For
active TCP sessions the IP address will display which of the devices
addresses the session was established with. For raw sockets this
displays the IP address and IP protocol for which the socket will
accept IP packets. The address and protocol are separated by ':' . If
the socket will accept packets addressed to any of the device's IP
addresses, the IP address will be 0.0.0.0 for IPv4 and :: for IPv6. IP
Protocol assignments are described
at:www.iana.org/assignments/protocol-numbers
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
:::*
0.0.0.0:*
0.0.0.0:*
0.0.0.0:*
:::*
0.0.0.0:*
:::*
:::*
LISTEN
112
58
112
596