Maximum-Paths - Centrecom FS980M/9 Command Reference Manual

R C
OUTING OMMANDS
-
MAXIMUM PATHS

maximum-paths

Overview This command enables ECMP on your device, and sets the maximum number of
paths that each route has in the Forwarding Information Base (FIB). ECMP is
enabled by default.
The no variant of this command sets the maximum paths to the default of 4.
Syntax maximum-paths <1-8>
no maximum-paths
Default By default the maximum number of paths is 4.
Mode Global Configuration
Examples To set the maximum number of paths for each route in the FIB to 5, use the
command:
awplus#
awplus(config)#
To set the maximum paths for a route to the default of 4, use the command:
awplus#
awplus(config)#
613-50137-01 Rev A
Parameter Description
<1-8>
The maximum number of paths that a route can have in the FIB.
configure terminal
maximum-paths 5
configure terminal
no maximum-paths
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
637