Mpls L2Vpn Configuration Examples; Configuring Local Mpls L2Vpn Connections - HP MSR2000 Configuration Manual

MPLS L2VPN configuration examples

Configuring local MPLS L2VPN connections

Network requirements
Configure local MPLS L2VPN connections between PE and CEs so that CE 1 and CE 2 can communicate
with each other at Layer 2 through GigabitEthernet 2/1/1 and GigabitEthernet 2/1/2 on the PE.
Figure 97 Network diagram
Configuration procedure
1. Configure CE 1.
<CE1> system-view
[CE1] interface gigabitethernet 2/1/1
[CE1-GigabitEthernet2/1/1] ip address 100.1.1.1 24
[CE1-GigabitEthernet2/1/1] quit
2. Configure CE 2.
<CE2> system-view
[CE2] interface gigabitethernet 2/1/1
[CE2-GigabitEthernet2/1/1] ip address 100.1.1.2 24
[CE2-GigabitEthernet2/1/1] quit
3. Configure PE:
# Enable L2VPN.
<PE> system-view
[PE] l2vpn enable
# Create a cross-connect group named vpn1, create a cross-connect named vpn1 in the group,
and bind GigabitEthernet 2/1/1 to GigabitEthernet 2/1/2 on the cross-connect.
[PE] xconnect-group vpn1
[PE-xcg-vpn1] connection vpn1
[PE-xcg-vpn1-vpn1] ac interface gigabitethernet 2/1/1
[PE-xcg-vpn1-vpn1] ac interface gigabitethernet 2/1/2
[PE-xcg-vpn1-vpn1] quit
Verifying the configuration
# Display AC forwarding entries on PE. The output shows two AC forwarding entries.
[PE] display l2vpn forwarding ac
391