Honda ACCORD HYBRID 2005 Service Manual page 1240

Steering
S t e e r i n g W h e e l I n s t a l l a t i o n
1. Before installing the steering w h e e l , make sure the
front wheels are aligned straight ahead, then center
the cable reel (A). Do this by first rotating the cable
reel clockwise until it stops. Then rotate it
counterclockwise about three full turns. The a r r o w
mark (B) on the cable reel label point should point
straight up.
2. Position the t w o tabs (A) of the t u r n signal
cancelling sleeve (B) as s h o w n . Install the steering
wheel on to the steering c o l u m n shaft, making sure
the steering wheel hub (C) engages the pins (D) of
the cable reel and tabs of the canceling sleeve. Do
not tap on the steering w h e e l or steering c o l u m n
shaft w h e n installing the steering w h e e l .
B
3. Install the steering wheel bolt (A) and tighten it to
the specified torque. Connect the steering switch
connector (B). Make sure the w i r e harness is routed
and fastened properly.
4. Install the driver's airbag (see page 24-139).
5. Reconnect the negative cable to the battery and do
the f o l l o w i n g items:
NOTE: If the IMA battery level gauge (BAT) displays
no segments, start the engine, and hold it between
3,500 r p m and 4,000 r p m w i t h o u t load (in Park or
neutral) until the BAT displays at least three
segments.
• Power w i n d o w control unit reset procedure
(see page 22-200).
• Enter the anti-theft codes for the radio and the
navigation system, then enter the X M radio
channel presets.
• Set the clock.
• Verify cruise control, audio remote, navigation
voice control, and t u r n signal switch operation.
• Make sure the steering w h e e l is centered.
17-8