Honda ACCORD HYBRID 2005 Service Manual page 1424

A B S / T C S Components
A B S / T C S M o d u l a t o r - C o n t r o l U n i t R e m o v a l a n d I n s t a l l a t i o n ( c o n t ' d )
Installation
1. Install the ABS/TCS modulator-control unit to the b r a c k e t then tighten the t w o 6 m m bolts and the hex bolt.
2. Install the ABS/TCS modulator-control unit/bracket, then tighten the three 6 m m bolts.
3. Reconnect the six brake lines, then tighten the nuts.
4. A l i g n the connecting surface of the ABS/TCS control unit 47P connector.
5. Push in the lock of the ABS/TCS control unit 47P connector until you hear it click into place, then connect the
connector.
6. Bleed the brake system, starting w i t h the front wheels.
7. Perform the TCS pressure sensor neutral position memorization (see page 19-78).
8. Start the engine, and check that the ABS, TCS and TCS activation indicators goes off.
9. Test-drive the vehicle, and check that the ABS, TCS and TCS activation indicators do not c o m e on.
19-80