Mirror Holder Replacement - Honda ACCORD HYBRID 2005 Service Manual

Mirror Holder Replacement
NOTE: Put on gloves to protect y o u r hands.
1. Carefully push on the top edge of the mirror holder
(A) by hand.
2. Put a shop t o w e l in the opening between the lower
edge of the mirror holder and the mirror housing
(B) to prevent scratches, and detach the b o t t o m
clips (C) w i t h a flat-tip screwdriver w r a p p e d w i t h
protective tape.
3. Carefully pull out the b o t t o m edge of the m i r r o r
holder (A) to separate the adhesive (B), and then
release the side clips (C).
4. Separate the mirror holder f r o m the actuator (D) by
releasing the hooks (E). If equipped, disconnect the
m i r r o r defogger connectors (F).
5. Before reinstalling the m i r r o r holder to the inner
holder (A) of the actuator, check the actuator rods
(B) and the actuator boots (C):
• If each rod is off the actuator hole, insert it
securely.
• The w h o l e of each rod should be covered w i t h
the boot. If not, adjust the boot into proper
position.
A
OK NO GOOD
(cont'd)
20-29