Honda ACCORD HYBRID 2005 Service Manual page 1199

C a r r i e r B e a r i n g O u t e r R a c e R e p l a c e m e n t
Special Tools Required
• Driver 07749-0010000
• Attachment, 83 m m 07HAD-SG00100
• Attachment, 78 x 80 m m 07NAD-PX40101
NOTE:
• Replace the bearing w i t h a new one whenever the
outer race is replaced.
• Do not use shim(s) on the torque converter housing
side.
• Adjust the preload after replacing the bearing and the
outer race.
• Coat all parts w i t h ATF during installation.
1. Remove the bearing outer race (A), spacer (B), and
85 m m thrust shim (C) f r o m the transmission
housing (D) by heating the housing to about 212 °F
(100 °C) w i t h a heat gun (E). Do not heat the
housing more than 212 °F (100 °C).
3. Install the 85 m m thrust s h i m (A), spacer (B), and
outer race (C) in the transmission housing (D).
4. W i t h the special tools, drive the outer race securely
in the housing so there is no clearance between the
outer race, spacer, s h i m , and housing.
07749-0010000
0 7 H A D S G 0 0 1 0 0
2. Remove the bearing outer race f r o m the torque
converter housing.
(cont'd)
14-363