Honda ACCORD HYBRID 2005 Service Manual page 1495

D r i v e r ' s D a s h b o a r d L o w e r C o v e r
R e m o v a l / I n s t a l l a t i o n
NOTE:
• Take care not to scratch the dashboard and related
parts.
• W h e n prying w i t h a flat-tip screwdriver, w r a p it w i t h
protective tape to prevent damage.
1. Adjust the steering c o l u m n u p w a r d .
2. Remove the screw (A).
F a s t e n e r L o c a t i o n s „ _
3. Pull out the b o t t o m of the driver's dashboard lower
cover (B) to detach the lower clips (C).
4. Detach the upper clips (D) and a hook (E) by pulling
the driver's dashboard lower cover back.
5. If any of the clips (C, D) securing the driver's
dashboard lower cover is hard to detach, pry it w i t h
a flat-tip screwdriver.
6. Remove the driver's dashboard lower cover (A).
Disconnect the TCS off switch connector (B).
7. Install the cover in the reverse order of r e m o v a l ,
and make sure the TCS off switch connector is
plugged in properly.
D r i v e r ' s D a s h b o a r d U n d e r C o v e r
R e m o v a l / I n s t a l l a t i o n
NOTE: Take care not to scratch the dashboard and
related parts.
1. Remove the driver's dashboard lower cover
(see page 20-67).
2. Remove the driver's dashboard under cover (A).
- 1 Gently pull d o w n the rear edge to detach the
clips.
- 2 Pull the cover away to release the pins (B) f r o m
the holders (C).
Fastener Locations
\> : Clip, 3
3. Install the cover in the reverse order of r e m o v a l .
20-67