Honda ACCORD HYBRID 2005 Service Manual page 1364

Conventional Brake Components
B r a k e B o o s t e r R e p l a c e m e n t ( c o n t ' d )
10. Remove the lock pin (A) and the joint pin (B), then
disconnect the yoke f r o m the brake pedal.
8 x 1.25 m m
13 N m
(1.3 k g f m , 9.4 Ibf-ft)
11. Remove the brake booster m o u n t i n g nuts (C).
12. Remove the brake booster (A) f r o m the engine
c o m p a r t m e n t .
I NOTICE I
• Be careful not to damage the booster
surfaces and threads of the booster stud
bolts.
• Be careful not to bend or damage the
brake lines.
A
13. Install the brake booster in the reverse order of
removal, and note these items:
• After installing the brake booster and master
cylinder, fill the reservoir w i t h new brake fluid,
bleed the brake system (see page 19-9), and
adjust the brake pedal height and free play
(see page 19-5).
• If the IMA battery level gauge (BAT) displays no
segments, start the engine, and hold it between
3,500 r p m and 4,000 r p m w i t h o u t load (in Park or
neutral) until the BAT displays at least three
segments.
• Do the PCM idle learn procedure (see page
11-340).
• Do the power w i n d o w control unit reset
procedure (see page 22-200).
• Enter the anti-theft codes for the radio and the
navigation system, then enter the customer's
radio and X M channel presets.
19-20