Mitsubishi Electric GT14 User Manual page 1540

The following shows the number of the connectable nodes when a repeater hub is used.
• 10BASE-T: Max. 4 nodes for a cascade connection (500m)
• 100BASE-TX: Max. 2 nodes for a cascade connection (205m)
When switching hubs are used, the cascade connection between the switching hubs has no logical limit for the number of
cascades.
For the limit, contact the switching hub manufacturer.
*4 Use C or later version of GT11H-C-37P.
HINT HINT HINT
System configuration between the GOT and PLC
For the system configuration between the GOT and PLC, refer to each chapter.
65.3 GOT Side Settings
65.3.1 VNC(R) server function setting
2.
1.
Select [Common]
Server] from the menu.
2.
Check [Use VNC Server] of [VNC Server] to set.
For details on the settings, refer to the following.
GT Designer3 Version1 Screen Design Manual
(Functions)
OK
Click the button when settings are completed.
65 - 2
65. VNC(R) SERVER CONNECTION
65.3 GOT Side Settings
Mitsubishi Products
Non-Mitsubishi Products 1, Non-Mitsubishi Products 2
Microcomputer, MODBUS Products, Peripherals
Click!
[Peripheral Setting] [VNC
65.3.2 Setting communication interface
(Communication settings)
®
For using the VNC server, install an Ethernet
communication driver to the GOT and set the
communication interface.
2.
1.
Select [Common] [Controller Setting] from the menu.
2.
The Controller Setting window is displayed. Select the
channel to be used from the list menu.
3.
Set Manufacturer, Controller Type, I/F, and Driver
according to the connected equipment to be used.
4.
The detailed setting is displayed after Manufacturer,
Controller Type, I/F, and Driver are set.
Make the settings according to the usage
environment.
OK
Click the button when settings are completed.
3.
4.
Click!