Identify Faulted Components - Oracle SPARC T7-2 Service Manual

Identify Faulted Components

The fmadm faulty command displays the list of faults detected by PSH. You can run this
command from the host or through the Oracle ILOM fault management shell.
1.
From the Oracle ILOM prompt, start the fault management shell and type fmadm
faulty.
This example shows how to check for faults through the Oracle ILOM fault management shell.
You can also check for faults by typing show faulty at the Oracle ILOM prompt.
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y
faultmgmtsp> fmadm faulty
------------------- ------------------------------------ -------------- -------
Time
------------------- ------------------------------------ -------------- -------
2015-01-16/17:55:26 f4ee56c-9fdd-ca19-efb5-ae39675dfee3 SPT-8000-PX
Problem Status : open
Diag Engine : fdd 1.0
System
Manufacturer : Oracle Corporation
Name : SPARC T7-2
Part_Number : 12345678+11+1
Serial_Number : 1238BDC0DF
----------------------------------------
Suspect 1 of 1
Fault class : fault.component.misconfigured
Certainty : 100%
Affects : /SYS/MB/CM1/CMP/MR3/BOB1/CH1/DIMM
Status : faulted
FRU
Status : faulty
Location : /SYS/MB/CM1/CMP/MR3/BOB1/CH1/DIMM
Manufacturer
Name
Part_Number
Revision
Serial_Number
Chassis
Manufacturer
Name
Part_Number
UUID
: Hynix Semiconductor Inc.
: 8192MB DDR4 SDRAM DIMM
: 70xx001,HMA4xxR7MFRxx-TFT7
: 01
: 465769T+02xxx102WR
: Oracle Corporation
: SPARC T7-2
: 12345678+13+2
Identify Faulted Components
msgid Severity
Major
Detecting and Managing Faults 31