Identify Faulted Components - Oracle SPARC M8 Service Manual

Identify Faulted Components

Step
1.
2.
3.
4.
5.
Identify Faulted Components
The fmadm faulty displays a list of faults detected by PSH. You can run this command from
either the host or through the Oracle ILOM fault management shell. This example shows how to
check for faults through the Oracle ILOM fault management shell. You can also check for faults
by typing show faulty at the Oracle ILOM prompt.
Note -
identify all components that require service so they can be replaced at the same time. Doing so
will minimize down time and reduce service calls.
1.
At the Oracle ILOM prompt start the fault management shell, and then type fmadm
faulty.
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y
faultmgmtsp> fmadm faulty
------------------- ------------------------------------ ------------- --------
Time
------------------- ------------------------------------ ------------- --------
2014-10-27/10:20:25 18b66cdc-aa00-c614-a50f-eed199043bd7 SPT-8000-5X Major
Problem Status
Diag Engine
36 SPARC M8 and SPARC M7 Servers Service Manual • September 2017
Description
Run the fmadm faulty command to
display information about components
that require service.
Run the show disabled command to
display information about components
that have been disabled either
intentionally or because of a failure.
Identify the names of components that
require service as reported by diagnostic
software.
Learn about fault tolerances that exist for
specific components and guidelines for
replacing them.
View the server components using the
Oracle ILOM chassis view.
When you examine the output generated by running the fmadm faulty command,
UUID
: open
: fdd 1.0
Links
"Identify Faulted Components" on page 36
"Identify Disabled Components" on page 38
"Component Oracle ILOM State
Properties" on page 39
"Component Names Displayed by Diagnostic
Software" on page 40
"Component Fault Tolerances" on page 42
"Oracle ILOM Chassis View" on page 44
msgid Severity