Verify A Pcie Card - Oracle SPARC T8-4 Service Manual

If you replaced or installed a PCIe card in a powered-down server, power on
■
the server, then verify the PCIe card.
See "Returning the Server to Operation" on page 191
Card" on page 171
5. Take the PCIe card online. Do one of the following:
Press the ATTN button. The PCIe card carrier's Power OK LED should light,
■
indicating that the PCIe card is online.
■ Use the Oracle Solaris hotplug command.
For example:
# hotplug enable PCIE7
Related Information
"Understanding PCIe Root Complex Connections" on page 155
■
"PCIe Card Configuration" on page 158
■
"PCIe Carrier Handle and LEDs" on page 159
■
"Determine Which PCIe Card Is Faulty" on page 160
■
"Remove a PCIe Card Carrier" on page 161
■
"Remove a PCIe Card" on page 164
■
"Install a PCIe Card" on page 167
■
"Verify a PCIe Card" on page 171
■

Verify a PCIe Card

Verify that the Fault LED is not illuminated on the PCIe card.
1.
Verify that the System Service Required LEDs on the front panel and rear I/O
2.
module are not illuminated.
See "Interpreting LEDs" on page
3. Verify that the System PCIe Fault LED on the front panel is not illuminated.
See "Front Panel Controls and LEDs" on page
4. Consider your next steps.
27.
29.
Verify a PCIe Card
and "Verify a PCIe
Servicing PCIe Cards 171