Specifying the Cutting Method for Rolls
How rolls are cut after ejection varies depending on printer settings.
Automatic cut The roll is automatically cut by the cutter
blade according to the printer driver set-
Select this to move the cutter by touch
screen operation and cut paper. With Auto-
surface is be-
matic cut, the paper drops and may rub
against the basket, resulting in damage to
ed / to wait
the print surface, but you can cut using this
for ink to dry)
method and supporting the paper so that it
does not drop to avoid damage to the pa-
per. Also, you can prevent paper that has
not dried from dropping by visually check-
ing the ink has dried, and then cutting the
After printing, tap Cut paper and cut the
roll paper on the cutter blade.
Select this if the paper cannot be cut on the
Cut each page from the roll using scissors.
cannot be cut
For continuous printing (if you will cut each
with the cut-
page later), select Automatic Cutting >
Yes or select Print Cut Guideline.
Select this when you want to cut the roll pa-
(to have the
per by operating the cutter blade using the
roll cut at
touch screen after printing with No or Print
Cut Guideline selected in Automatic Cut-
ting in the printer driver.
Otherwise choose this option if you want to
cut the roll edge after loading a roll.
• Automatic and Eject are valid only when you have selected Automatic Cutting > Yes in the printer
• With Eject, printing does not resume after a series of jobs have been printed continuously until the roll is
• Eject cut is the preset selection in Cutting mode for some types of paper. For this paper, we
recommend keeping the preset cutting mode.
2 > Paper
No, Yes, Print
No, Print Cut